Controller wall mount

wall mounted controller mount / holder, designed to print fast with 0.8mm nozzle, I used cura 5.2.1 basic pla+ settings, on its side, with raft, with hortrizontal expansion @ -0.02 so as to allow for single pass without any travels (thickness is 1.6mm / 3.2 @ top fold, also hence gap in horizontal support), hole(s) to be drilled as much faster to print. adhering to wall with pink grip or hanging strip would work for less invasive approach. this printed in 35min in pla+ @ 80mm/s with bed @ 60 and nozzle at 220 on stock cr10, if widened to 66mm it fits ps4 controller perfectly on the d-pads for frontal orientation but would obviously take longer to print 🙂

Pythagorean CR-10 Perfect 90⁰ Z Supports

Made using 640mm 2020 aluminium v-slot profile shortened to exact measure, and made to utilise the end hole centres of the 2040 Z and Y sections of the Cr10.

The angles and length of aluminium extrusion may need to be adapted to match your printer exactly, I actually enlarged the original M5 holes and tapped them to fit the 12mm 84⁰ countersunk M6 bolts for a cleaner self centering fit as the extrusion came with a 5.2mm end hole ideal for an M6 standard pitch thread.

These are printed in basic resin on Photon S SLA and are very sturdy, but do also work really well in PLA+ as I tested just one side but the resin was quicker and took far less finishing.